What MHUB systems does uControl Remote support?
uControl Remote will work with any HDA system marked “uControl inside”. These are typically MHUB’s, MZMA or uControl Zone Processors which shipped with uControl OS (uOS) version 10 or above. MHUB’s which were installed with MHUB-OS (MOS) will not support the uControl Remote, but some can be upgraded (see below).
| List of systems that support uControl Remote | ||
|---|---|---|
Natively Supported |
||
| MHUB (4×1+1) 40 | ||
| MHUB (4×4) 100A | ||
| MHUB (6×6) 100A | ||
| MHUB S (8+8×8) 100A | ||
| MHUB S (16+16×16) 100A | ||
| MZMA (6×4) 55 | ||
| uControl Zone Processor 1 | ||
| uControl Zone Processor 5 | ||
| uControl Connect Processor | ||
UpgradableREQUIRES A UCONTROL ZONE PROCESSOR 1 |
||
| MHUB PRO 2.0 (4×4) 40 | ||
| MHUB PRO 2.0 (8×8) 100 | ||
| MHUB U (4×3+1) 40 (coming soon) | ||
| MHUB U (8×6+2) 40 (coming soon) |
Supported Stacked SystemsREQUIRES A UCONTROL ZONE PROCESSOR 1 |
|
| MHUB PRO 2.0 (4×4 & 8×8) & MZMA | ||
| MHUB S (100A) & MZMA | ||
| MHUB S (100) + MHUB S (100A) | ||